Range Rover Workshop Manual - Eng - Landiesrus

LAND ROVER V8STRAINER - OIL PICK-UPService repair no - 12.60.20Remove1. Remove sump gasket. See this section.7. Disconnect Lucar from oil pressure switch.8. Position container below switch to catch oilspillage.9. Remove oil pressure switch and discard ’O’ ring.Refit10. Clean oil pressure switch threads.11. Fit new ’O’ ring to switch.12. Fit oil pressure switch and tighten to 15 Nm (11lbf.ft).13. Connect Lucar.14. Ensure oil cooler return pipe union is clean andfit new ’O’ ring to pipe.15. Align oil cooler return pipe to alternator supportbracket and fit but do not tighten bolt at thisstage.16. Tighten oil cooler return pipe union to 15 Nm (11lbf.ft).17. Tighten bolt securing oil cooler return pipe toalternator support bracket.18. Fit oil filter. See this section.19. Connect battery earth lead.20. Fit battery cover and secure with fixings.21. Top up engine oil.2. Remove 2 bolts and 1 nut securing oil pick-upstrainer.3. Remove oil pick-up strainer.4. Collect spacer from stud.5. Remove and discard ’O’ring.Refit6. Clean oil pick-up strainer and ’O’ ring recess.7. Lubricate and fit new ’O’ ring.8. Locate spacer on stud.9. Position oil pick-up strainer, fit and tighten, boltsto 10 Nm (7 lbf.ft) and, nut to 22 Nm (17 lbf.ft).10. Fit new sump gasket. See this section.REPAIR41