Range Rover Workshop Manual - Eng - Landiesrus

12ENGINE NEW RANGE ROVERROCKER COVER GASKET (LH) - from 99MYService repair no - 12.29.40Remove1. Remove upper inlet manifold gasket SeeMANIFOLD AND EXHAUST SYSTEM, Repair.Refit6. Clean mating faces of rocker cover and cylinderhead.7. Position new gasket on cylinder head.8. Locate rocker cover on gasket and installsecuring bolts.9. Ensure gasket outer rim is correctly locatedaround periphery of rocker cover, then tightenbolts in diagonally opposite sequence to:Stage 1 - 3 Nm (2.2 lbf.ft).Stage 2 - 7 Nm (5.2 lbf.ft).10. Fit and tighten screw securing dip stick tube.11. Fit plug leads to clips on rocker cover.12. Fit upper inlet manifold gasket. See MANIFOLDAND EXHAUST SYSTEM, Repair.2. Release HT leads from clips on rocker cover.3. Remove screw securing dip stick tube.4. Remove and discard 4 bolts securing rockercover.5. Remove rocker cover and gasket.44 REPAIR