Range Rover Workshop Manual - Eng - Landiesrus

12ENGINE NEW RANGE ROVERRefit7. Clean timing chain, gears and gear locations.8. Fit key to crankshaft.9. Temporarily fit gears to camshaft and crankshaft.If necessary, rotate shafts to align timing marks.NOTE: When aligned correctly, the timingmarks will face each other: the crankshaftgear with its timing mark at twelve 0’clockposition and the camshaft with its timing mark atsix 0’clock position.3. Restrain camshaft gear and remove gearretaining bolt.4. Remove camshaft drive chain and gears as anassembly.5. Remove gears from chain.6. If necessary remove key from crankshaft.10. Remove gears from shafts and fit to timingchain.11. With timing marks aligned, fit timing chain andgears as an assembly.12. Restrain the camshaft gear and tighten retainingbolt to 50 Nm (37 lbf.ft).13. Fit front cover gasket See this section.14. Reconnect battery negative lead.56 REPAIR