Range Rover Workshop Manual - Eng - Landiesrus

LAND ROVER V8NOTE: Long bolts: 1, 3, 5.CYLINDER HEAD GASKET (RH) - from 99MYService repair no - 12.29.03Remove1. Remove inlet manifold gasket. See MANIFOLDAND EXHAUST SYSTEM, Repair.2. Remove RH exhaust manifold gasket. SeeMANIFOLD AND EXHAUST SYSTEM, Repair.NOTE: RHD models: Exhaust manifold willremain captive in engine bay but clear ofcylinder head.15. Fit bolts and tighten in the sequence shown to20 Nm (15 lbf.ft) then 90 ° , then a further 90 ° .16. Clean push rods.17. Lubricate ends of push rods with clean engineoil.18. Fit push rods in their removed order.19. Clean base of rocker pillars and mating faces oncylinder head.20. Clean contact surface on rockers, valves andpush rods.21. Lubricate contact surfaces and rocker shaft withclean engine oil.22. Fit rocker shaft assembly and engage push rods.23. Tighten rocker shaft securing bolts progressivelyto 38 Nm (28 lbf.ft).24. Fit and tighten engine harness bolt to 20 Nm (15lbf.ft).25. Refit rocker cover.26. Ensure dipstick tube and mating face on cylinderblock is clean.27. Apply Loctite 638 to end of dipstick tube and fittube and dipstick to cylinder block.28. Fit exhaust manifold. See MANIFOLD ANDEXHAUST SYSTEM, Repair.29. Fit inlet manifold gasket. See MANIFOLD ANDEXHAUST SYSTEM, Repair.3. Remove bolt securing auxiliary drive belttensioner and remove tensioner.REPAIR53