Range Rover Workshop Manual - Eng - Landiesrus

LAND ROVER V88. Inspect tappet body for excessive wear orscoring.NOTE: If scoring or deep wear patternsextend up to oil feed area, replace tappet.9. Inspect pushrod seats in tappets. If surface isrough or pitted, replace tappet.10. Clean and inspect tappet bores in engine block.11. Ensure that tappets rotate freely in theirrespective bores.12. Inspect pushrods for straightness.13. Inspect pushrod contact surfaces. If surfaces arerough or pitted, replace pushrod.14. Inspect pushrod seats in valve rocker arms. Ifsurfaces are rough or pitted, replace rocker arm.CYLINDER HEAD GASKET (LH) - from 99MYService repair no - 12.29.02Remove1. Remove inlet manifold gasket See MANIFOLDAND EXHAUST SYSTEM, Repair.2. Remove exhaust manifold gasket SeeMANIFOLD AND EXHAUST SYSTEM, Repair.Refit15. Immerse tappets in clean engine oil.16. Lubricate tappet bores with clean engine oil.17. Refit tappets in removed order.18. Refit pushrods in removed order.19. Refit rocker shaft assemblies. See this section.20. Refit inlet manifold gasket. See MANIFOLDAND EXHAUST SYSTEM, Repair.21. Reconnect battery negative lead.3. Remove dipstick and dipstick tube. Remove fourscrews securing rocker cover and remove rockercover.4. Remove bolt securing engine harness to rear ofcylinder head.REPAIR51