Range Rover Workshop Manual - Eng - Landiesrus

LAND ROVER V8ROCKER COVER GASKET (RH) - from 99MYService repair no - 12.29.41Remove1. Drain cooling system. See COOLING SYSTEM,Repair.2. Remove upper inlet manifold gasket. SeeMANIFOLD AND EXHAUST SYSTEM, Repair.9. Remove and discard 4 bolts securing rockercover.10. Remove rocker cover and gasket.Refit3. Release engine harness clip from coolant railand move harness clear of rocker cover.4. Release clips and disconnect coolant hosesfrom heater.5. Remove 2 bolts securing coolant rails and moveouter rail clear of rocker cover.6. Remove bolt securing inner coolant rail to inletmanifold, remove rail and discard ’O’ ring.7. Release HT leads from clips on rocker cover.11. Clean mating faces of rocker cover and cylinderhead.12. Position new gasket on cylinder head.13. Locate rocker cover on gasket and installsecuring bolts.14. Ensure gasket outer rim is correctly locatedaround periphery of rocker cover, then tightenbolts in diagonally opposite sequence to:Stage 1 - 3 Nm (2.2 lbf.ft).Stage 2 - 7 Nm (5.2 lbf.ft).15. Connect HT leads to spark plugs and fit leads toclips on rocker cover.16. Clean coolant rail ’O’ ring recess.17. Lubricate and fit new ’O’ ring to coolant rail, fitrail to inlet manifold and tighten bolt to 22 Nm(16 lbf.ft).18. Align outer coolant rail and fit and tighten bolts.19. Connect coolant hoses to heater and securewith clips.20. Reposition engine harness and secure with clipto coolant rail.21. Fit upper inlet manifold gasket. See MANIFOLDAND EXHAUST SYSTEM, Repair.22. Refill cooling system. See COOLING SYSTEM,Repair.8. Disconnect HT leads from spark plugs and moveclear of rocker cover.REPAIR45