27.11.2012 Views

High Resolution 1:10,000 scale Mapping Strategy of Multi ... - NDMA

High Resolution 1:10,000 scale Mapping Strategy of Multi ... - NDMA

High Resolution 1:10,000 scale Mapping Strategy of Multi ... - NDMA

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

may be cause for rejection. However, consideration shall be given if, in<br />

the case <strong>of</strong> a stereoscopic pair, endlap exceeding sixty-eight percent<br />

(68%) was found to be unavoidable in areas <strong>of</strong> low elevation in order to<br />

attain the fifty-five percent (55%) minimum endlap in adjacent areas <strong>of</strong><br />

higher elevation.<br />

3. Sidelap: Sidelap shall average thirty percent (30%), plus or minus ten<br />

percent (<strong>10</strong>%). Any negative having sidelap less than fifteen (15%) or<br />

greater than fifty percent (50%) may be rejected. However, consideration<br />

shall be given if the strip area to be mapped is found to be slightly wider<br />

than the area which can be covered in one flight strip. In that case,<br />

sidelap <strong>of</strong> up to seventy percent (70%) to take advantage <strong>of</strong> control is<br />

permissible.<br />

QUALITY OF PHOTOGRAPHY<br />

Photography shall be executed so as to minimize image movement at the<br />

moment <strong>of</strong> exposure. Such exposure and the subsequent processing shall be<br />

such that all negatives shall be <strong>of</strong> high quality showing all specified planimetric<br />

and topographic features at stipulated <strong>scale</strong><br />

Negatives should be clear and sharp in detail and in average contrast and<br />

without static marks, stains and other blemishes.<br />

SCALE OF NEGATIVES<br />

The flight height above the average ground elevation or set datum shall be such<br />

that the negatives will yield photographic prints on paper or on dimensionally<br />

stable polyester-type plastic or on optically flat glass plates to the <strong>scale</strong><br />

specified. Negatives departing from the intended <strong>scale</strong> by more than five percent<br />

(5%) shall be rejected.<br />

140

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!