RBT-001 Module - User Manual v.1.2

More documents

Recommendations

Info

RoboTech Bluetooth Serial ModuleUser Manual Ver. 1.223OpcodeValueGAP_REMOTE_DEVICE_NAME0x02GAP_READ_LOCAL_NAME0x03GAP_WRITE_LOCAL_NAME0x04GAP_READ_LOCAL_BDA0x05GAP_SET_SCANMODE0x06GAP_GET_FIXED_PIN0x16GAP_SET_FIXED_PIN0x17GAP_GET_PIN0x75GAP_GET_SECURITY_MODE0x18GAP_SET_SECURITY_MODE0x19GAP_REMOVE_PAIRING0x1BGAP_LIST_PAIRED_DEVICES0x1CGAP_ENTER_SNIFF_MODE0x21GAP_EXIT_SNIFF_MODE0x37GAP_ENTER_PARK_MODE0x38GAP_EXIT_PARK_MODE0x39GAP_ENTER_HOLD_MODE0x3AGAP_SET_LINK_POLICY0x3BGAP_GET_LINK_POLICY0x3CGAP_POWER_SAVE_MODE_CHANGED0x3DGAP_ACL_ESTABLISHED0x50GAP_ACL_TERMINATED0x51SPP_SET_PORT_CONFIG0x07SPP_GET_PORT_CONFIG0x08SPP_PORT_CONFIG_CHANGED0x09SPP_ESTABLISH_LINK0x0ASPP_LINK_ESTABLISHED0x0BSPP_INCOMMING_LINK_ESTABLISHED0x0CSPP_RELEASE_LINK0x0DSPP_LINK_RELEASED0x0ESPP_SEND_DATA0x0FSPP_INCOMING_DATA0x10SPP_TRANSPARENT_MODE0x11SPP_CONNECT_DEFAULT_CON0x12SPP_STORE_DEFAULT_CON0x13SPP_GET_LIST_DEFAULT_CON0x14SPP_DELETE_DEFAULT_CON0x15SPP_SET_LINK_TIMEOUT0x57SPP_GET_LINK_TIMEOUT0x58SPP_PORT_STATUS_CHANGED0x3ESPP_GET_PORT_STATUS0x40
RoboTech Bluetooth Serial ModuleUser Manual Ver. 1.224OpcodeValueSPP_PORT_SET_DTR0x41SPP_PORT_SET_RTS0x42SPP_PORT_BREAK0x43SPP_PORT_OVERRUN_ERROR0x44SPP_PORT_PARITY_ERROR0x45SPP_PORT_FRAMING_ERROR0x46SDAP_CONNECT0x32SDAP_DISCONNECT0x33SDAP_CONNECTION_LOST0x34SDAP_SERVICE_BROWSE0x35SDAP_SERVICE_SEARCH0x36SDAP_SERVICE_REQUEST0x1ESDAP_ATTRIBUTE_REQUEST0x3FCHANGE_NVS_UART_SPEED0x23CHANGE_UART_SETTINGS0x48SET_PORTS_TO_OPEN0x22GET_PORTS_TO_OPEN0x1FRESTORE_FACTORY_SETTINGS0x1ASTORE_CLASS_OF_DEVICE0x28FORCE_MASTER_ROLE0x1DREAD_OPERATION_MODE0x49WRITE_OPERATION_MODE0x4ASET_DEFAULT_LINK_POLICY0x4CGET_DEFAULT_LINK_POLICY0x4DSET_EVENT_FILTER0x4EGET_EVENT_FILTER0x4FSET_DEFAULT_LINK_TIMEOUT0x55GET_DEFAULT_LINK_TIMEOUT0x56SET_DEFAULT_LINK_LATENCY0x63GET_DEFAULT_LINK_LATENCY0x64SET_PCM_SLAVE_CONFIG0x74ENABLE_SDP_RECORD0x29DELETE_SDP_RECORDS0x2ASTORE_SDP_RECORD0x31RESET0x26RBT-001_READY0x25TEST_MODE0x24WRITE_ROM_PATCH0x47READ_RSSI0x20RF_TEST_MODE0x4BDISABLE_TL0x52
Page 1: RoboTechBluetooth Serial ModuleRBT-
Page 5 and 6: Release Link.......................
Page 7 and 8: Product DescriptionThe RoboTech Blu
Page 9 and 10: Recommended Operating ConditionsSym
Page 11 and 12: RS232 adapter board schematicRoboTe
Page 13 and 14: Command mode and Transparent modeCo
Page 15 and 16: No. Address Parameter Default Value
Page 17 and 18: Force Master on/offThis flag improv
Page 19 and 20: Idle, Automatic and Idle, Non-autom
Page 21 and 22: Default Connection setup by using "
Page 23: UART Protocol PrinciplesThe RBT-001
Page 27 and 28: Commands in Command ModeThe RBT-001
Page 29 and 30: Reading the user-friendly name of t
Page 31 and 32: Set Scan ModeDescriptionChange the
Page 33 and 34: DescriptionResponse to the request
Page 37 and 38: DescriptionThis command is used to
Page 41 and 42: Serial port profile (SPP)An active
Page 43 and 44: LocalPort1 byteBaudRate1 bytePortse
Page 45 and 46: DescriptionConfirm to the request a
Page 47 and 48: Set Overrun ErrorDescriptionThis co
Page 49 and 50: Establish / Release SPP link to a r
Page 51 and 52: Link ReleasedDescriptionIndicates t
Page 53 and 54: If the link is lost, the RBT-001 wi
Page 55 and 56: DescriptionConfirm to the request a
Page 59 and 60: DescriptionPacketTypeOpcodeDataLeng
Page 61 and 62: DescriptionPacketTypeOpcodeDataLeng
Page 63 and 64: Read Operation ModeDescriptionThis
Page 65 and 66: DescriptionConfirms the request abo
Page 67 and 68: Get Event FilterDescriptionThis com
Page 69 and 70: Each registered service entry itsel
Page 71 and 72: Device ReadyDescriptionPacketTypeOp
Page 73 and 74: Read NVSDescriptionPacketType REQOp
Page 75 and 76:
0x260x270x280x290x2A0x2B0x2C0x2D0x2
Page 77 and 78:
Error MacroDescriptioncode0x30 ERRO
Page 79 and 80:
CertificationsBluetoothThe RBT-001
show all

RBT-001 Module - User Manual v.1.2

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?