RBT-001 Module - User Manual v.1.2

Device ReadyDescriptionPacketTypeOpcodeDataLengthDataTest ModeDescriptionThe device will send this indication to the host when the device is fullyinitialized and ready to receive commands from the host.INDDEVICE_READY1+LengthLength1 byteversion bytesPacketType REQOpcode TEST_MODEDataLength 1DataMode1 byteDescriptionPacketType CFMOpcode TEST_MODEDataLength 1DataStatus1 byteNumber of bytes in software version stringASCII string containing the software version. e.g. "0210" indicatingthat the software version is version 2.10.This command will activate the test mode. To exit the test mode, areset of the device must be performed. If local loopback mode isactivated all data send to the device though the UART, are send backto the host. The device can only leave local loopback mode byperforming a hardware reset.Confirms the request aboveThe Bluetooth test mode to enter:0x01 Enable Bluetooth test mode0x02 Enable local loopback modeERROR_OKERROR_ILLEGAL_TESTMODEERROR_UNKNOWN_ERRORERROR_INVALID_NO_OF_PARAMETERSRF_TEST_MODEDescriptionThis command will activate the RF test mode. To exit the test mode, areset of the device must be performed. The transmitter test must bestopped before a new test with changed parameters can be started.PacketType REQOpcode RF_TEST_MODEDataLength 14DataTest1 byteChannel1 byteTest Scenario:0x00: Stop transmit0x01: Burst transmit, take payload from this command0x02: Burst transmit, use PRBS-9 sequence0x03: Continuos transmit, sends all-1 if ModulationPayload isnonzero, otherwise all-00x04: Hopping receive0x05: continuos receive at fixed channelChannel number 0 – 780: 2402 MHz78: 2480 MHz255 (0xFF): Hopping in connection stateRoboTech Bluetooth Serial ModuleUser Manual Ver. 1.270