RBT-001 Module - User Manual v.1.2

DescriptionPacketTypeOpcodeDataLengthDataConfirms the request aboveCFMSDAP_SERVICE_BROWSE2+NoOfServices*(5+ NameLength)StatusERROR_OK1 byteERROR_INVALID_NO_OF_PARAMETERSERROR_RESULT_TOO_LARGEERROR_TRUNCATED_ANSWERNoOfServices Number of services found on remote device.1 byteFor each serviceBrowseGroupID The browse group UUID that the service belongs to.2 bytesServiceID The service UUID.2 bytesPortNrRFCOMM port number.1 byteNameLength The number of bytes in the service name1 byteServiceName The name of the service.NameLengthbytesService SearchThe SDAP Service Search command offers the ability to search for specific attributes for aservice. The attribute IDs can be found at the Bluetooth SIG website under “BluetoothAssigned numbers”.NOTE: As an exception to all other commands, this command does NOT required byteswapped parameters. So the UUIDs have to be filled in as defined in "Bluetooth SIG:Bluetooth Assigned Numbers,https://www.bluetooth.org/foundry/assignnumb/document/assigned_numbers".DescriptionPacketTypeOpcodeDataLengthDataThis command is used to search for services in the service record ofthe remote device.REQSDAP_SERVICE_SEARCH2 + 2*SearchPatternLength + 2*AttributesLengthSearchPatternLength Number of 16-bit UUID’s in Search pattern List. Note: Must be less1 bytesthan 86 elements.SearchPattern List of the requested services. The search pattern list is a list of 16-bit UUID’s of the requested services.AttributesLength Number of 16-bit UUID’s in attributeId list. Note: Must be less than1 byte86 elements.AttributesList of requested attributes for the requested services. The attributelist is a list of 16-bit UUID’s for the requested attributes.RoboTech Bluetooth Serial ModuleUser Manual Ver. 1.258