RBT-001 Module - User Manual v.1.2

Store Generic SDP RecordDescriptionPacketTypeOpcodeDataLengthDataDescriptionThis command will create a new service record in the local SDPdatabase, stored in the NVS.REQSTORE_SDP_RECORD5 + LocalPortThe local RFCOMM port used by this service. Range 1 to 30.1 byteAuthentication1 byteEncryption1 byteSdpRecordLength2 bytesSdpRecord BytesConfirms the request above0x00 No authentication requirements.0x02 Authentication is only required for this profile for incoming connections.0x20 Authentication is only required for this profile for outgoing connections.0x22 Authentication is required for this profile for connections in both directions0x00 No encryption requirements0x04 Encryption is only required for this profile for incoming connections.0x40 Encryption is only required for this profile for outgoing connections.0x44 Encryption is required for this profile for connections in both directionsThe number of bytes in the SDP record.The SDP record data formatted as: < uint16:AttributeId,SdpDataElement:AttributeData, uint16:AttributeId,SdpDataElement:AttributeData, …>. The maximum length for each service is255 bytes.PacketType CFMOpcode STORE_SDP_RECORDDataLength 2DataStatus1 byteERROR_OKERROR_INVALID_SDP_RECORDERROR_MAXIMUM_NO_OF_SERVICE_RECORDS_REACHEDIdentifier1 byteERROR_WRITING_TO_NVSA unique identifier, which must be used when dynamic enabling/disablingthe record.Other CommandsResetHostA p p lic a tio nR E Q , R E S E TRBT-001(Dongle)S im p ly B lu eIN D , D O N G L E _ R E A D YD o n g lep e rfo rm s are se tDescriptionPacketTypeOpcodeDataLength 0DataNoneThis command will perform a soft reset of the RBT-001. The RBT-001will send a DEVICE_READY indication when it has performed thereset.REQRESETRoboTech Bluetooth Serial ModuleUser Manual Ver. 1.269