RBT-001 Module - User Manual v.1.2

Get Event FilterDescriptionThis command reads the current event filter setting.PacketType REQOpcode GET_EVENT_FILTERDataLength 0DescriptionResponse to the request above.PacketType CFMOpcode GET_EVENT_FILTERDataLength 1DataFilter1 byte0x00: All events reported0x01: No ACL Link Indicators (default)0x02: No events reported, UART break still generated and detected.0x03: No events generated, UART break not generated or detected(full cable replacement)Set Default Link TimeoutDescriptionThis command is used to change the default link supervision timeout.The default link supervision timeout is set during connection setup.The default link supervision timeout setting is stored in NVS.PacketType REQOpcode SET_DEFAULT_LINK_TIMEOUTDataLength 2DataLinkTimeout2 byteDescriptionResponse to the request above.The link supervision timeout in slots (0,625ms). The default valuestored in the NVS after a factory reset is 20s.0x0000: No link supervision timeout (the timer is disabled)0x0190-0xFFFF: Valid timeout range (in slots)0x7D00: The default value (20s)PacketType CFMOpcode SET_DEFAULT_LINK_TIMEOUTDataLength 1DataStatus1 byteERROR_OKERROR_INVALID_NO_OF_PARAMETERSERROR_ILLEGAL_LINK_TIMEOUTGet Default Link TimeoutDescriptionThis command is used to read the default link supervision timeoutsetting from NVS.PacketType REQOpcode GET_DEFAULT_LINK_TIMEOUTDataLength 0DescriptionResponse to the request above.PacketType CFMOpcode GET_DEFAULT_LINK_TIMEOUTDataLength 2DataLinkTimeout2 byteThe link supervision timeout in slots.0x0000: No link supervision timeout (the timer is disabled)0x0190-0xFFFF: Valid timeout range (in slots)RoboTech Bluetooth Serial ModuleUser Manual Ver. 1.266