RENTAL SOLUTIONS GUIDE 2007 - TR Corporation

Megger BM21 500V/1/2/5kV Insulation Test Set
MEG,bM21 AU
Test voltages 25~5,000V in 25V steps. Insulation range to 1TΩ at 500V,
5TΩ at 5kV. AC/dc voltage measurement 50V~1kV. Leakage current
measurement. Capacitance measurement at end of test. Automatic
discharge of capacitance. In-built test timer. Insulation burn mode - short
circuit current 1mA nominal. battery life 8h, in-built charger for charging
from mains or 12V dc.
AVO/Megger BM11D Analogue/Digital 5kV Insulation Tester
MEG,bM11D AU/MY
Test voltages 500V, 1kV, 2.5kV and 5kV. Insulation range 10kΩ~500GΩ
digital. AC/dc voltage measurement 50V~1kV. Timer 0~60min. Automatic
discharge of capacitance. battery life 8h, in-built charger for charging from
mains or 12V dc.
Megger BM25 Insulation Tester
MEG,bM25 AU/NZ
Five kV insulation tester which is battery-powered, housed in a rugged case
and has a large, analogue/digital LCD. A built-in timer makes both spot
tests and polarisation Index (pI) testing easier to carry out. pre-set standard
test voltages at 500V, 1, 2.5 & 5kV with variable test voltage in 25V steps.
Displays capacitance at the end of a test to 10µF. Performs automatic PI,
Step Voltage and Dielectric Discharge tests as well as providing an optically
isolated RS232 port for downloading results during a test. Short circuit
current: nominal 1.8mA, max 2mA. battery life: typically 8h.
Megger CM500 Multifunction Installation Tester
MEG,CM500 AU/NZ
Combines the function of several instruments. Non-tripping loop test for
tests on RCD protected circuits. RCD ramp test features actual tripping
current. Functions are insulation, continuity, loop testing, RCD tests, voltage
& frequency measurement. Phase indication, outlet polarity indication.
Stores approximately 750 test results in memory for uploading to PC.
> NEW
Megger RCDT330 Residual Current Device Tester
MEG,RCDT330 AU
Tests standard, dc, selection and programmable RCDs. Ramp testing. Auto
(remote) testing. 3ph safe. Enables testing on 110V centre tapped supplied.
performs 1/21, 1xI & 50xI tests on RCDs rated at 10mA, 30mA, 100mA,
300mA, 500mA & 1000mA on general and selective (time delayed) RCDs.
Tough rubber armoured case with built-in cover. Weatherproof to Ip54. USb
interface for downloading test result.
LEM Saturn Insulation Tester
LEM,SATURNISO AU
Test voltages 50~1,000V in steps of 10V. Max range 30GΩ. Measures
ac/dc voltage to 600V, resistance to 30kΩ. Digital and analogue display.
Battery operated.
AUSTRALIA
1800 632 652
www.techrentals.com.au
inSulatiOn/cOnditiOn/reSiStance teSterS
NEW ZEALAND
0800 832 473
www.techrentals.co.nz
Megger CBT2 Earth Leakage Breaker Tester
MEG,CbT2 AU
Residual current device (RCD)/safety switch, circuit breaker tester. Twelve
ranges from 6~500mA. Displays tripping time in ms.
Metrel MI 2121 AUS Advanced RCD Tester
MET,MI2121AUS AU
Exceeds all requirements of AS/NZS3760:2003. Stores up to 500 tests.
Interface RS232 Software.
Megger BT51 Low Resistance Ohmmeter
MEG,bT51 AU
Uses 4 terminal method with helical duplex dual pronged probes. Test
current 2A nominal at 2Ω. Ranges 2, resolution 1mΩ, 20mΩ, resolution
10µΩ. Accuracy at 0~500C, ±1% of reading, ±2digits. Display LED 3½
digit. Power supply internal NiCd rechargeable batteries, typically around
2,000 tests at 5s duration. Re-charge time around 10h with 240Vac mains
power. Nett weight 45kgs.
Megger LT6 Digital Loop Tester
MEG,LT6 AU
Earth fault loop impedance tester 20Ω range 0.01Ω resolution, 2kΩ range
1Ω resolution. Single & 3ph systems can be tested. Used with MEG,CbT2
to test compliance to AS2381.1 (electrical wiring for hazardous areas).
Tests automatically when connection to circuit is made. Neons indicate fault
conditions.
Megger MFT1502 Combined Insulation, Loop & RCD Tester
MEG,MFT1502 AU
Tests fixed wiring in accordance with International and National Wiring
Standards. Display digital/analogue arc LCD. Voltage measurement
automatic selection ac or dc up to 270V. Continuity testing 200mA from
0.01~99.9Ω, automatic continuity testing commences the moment the test
probes touch the circuit to be tested. Audible tone to confirm test. Safety
check for presence of a voltage. Variable buzzer threshold selectable from
2~100Ω in 6 steps. Insulation testing 250, 500V & 1kV. Safety lockout
at voltages greater than 55V. Auto discharge facility safely discharges all
circuits after insulation test. Low current loop test, a 3-wire non-tripping
0.01Ω loop test designed to prevent RCD tripping. High current loop test
at 25A provides a fast test where no RCD is fitted. Supply voltage and
polarity indication at 55V~280V, 45Hz~65Hz phase to phase. phase~phase,
phase~neutral and phase~earth loop tests are possible. Loop measurements
from 55V~480V. prospective short~circuit current (pSC), a high current loop
test, is provided for rapid measurement of loop currents, both at the socket
outlet and distribution board. Ranges from 1A~19.9kA with a resolution of 1,
10 & 100A depending on range auto-ranging. RCD testing 10mA~1000mA
with both 0 & 180O phase angle. RCD ramp test measures the RCD trip
current. Displays actual trip current on all RCD ranges instead of trip time.
LED torch in illuminated probe for low light level areas. Ip54
ELECTRICAL POWER
MALAYSIA
603 5632 1135
www.techrentals.com.my 45