Instruction Manuals - Cole-Parmer

Instruction Manual pH 1100/ 210010.1.4 Meter general configuration setup submenusPress SETUP to enter setup mode. Use >/CAL to select meter, and then press ENTER. Use the Δ/MI and ∇/MR keys toscroll through submenus. There are 8 submenus (programs) in the meter setup mode:Date/Time Setup:P4.0Sets day, month, year, hour andminuteDat e/ Time Set up:P4.0Pr es s ENT. t o Sel ec tsee page 50Memory Clear Setup:P4.6Clears data from storedmemoryMem Cl ear Set up:P4.6Pr es s ENT. t o Sel ec tsee page 54Backlight Setup:P4.1-Turns backlight on or off andselects amount of timebacklight stays on after buttonpressData Log Setup:P4.2-Sets automatic or manualmemory recall and setsdatalogging time interval (10seconds to 23 hours, 59minutes, 59 seconds).Memory Recall Setup:P4.3-Selects automatic or manualmemory recall.Rs232 CommunicationSetup:P4.4-Sets Baud Rate (4800, 9600 or19200)-Sets Stop Bit (One or Two)-Sets Parity (None, Odd orEven)Backli ght Set up:P4.1Pr es s ENT. t o Sel ec tsee page 51Dat a Log Set up:P4.2Pr es s ENT. t o Sel ec tsee page 52MemRecal l Setup:P4.3Press ENT. t o Selectsee page 52Tx/ Rx Par amet er : P4.4Press ENT. t o Selectsee page 53Meter Reset:P4.7-Resets meter to factorydefaults-Resets baud rate to 9600-Resets stop bit to 2-Resets parity to EVEN-Clears all pH/mV/Ioncalibration data-Resets manual temperaturecompensation to 25.0°C-Resets pH/mV/Ionmeasurement alarm to OFF-Resets pH/mV/Ioncalibration due alarm toOFF-Resets stable indicator toON with low stability setting-Resets datalogging andmemory recall to manual-Resets backlight to ON with2.0 minute duration-Clears all data from storedmemoryMeter Reset :P4.7Pr es s ENT. t o Sel ec tsee page 54Data Transfer Setup:P4.5-Selects what data gets sent tocomputer/printer when PRINTDat a Tr ansf er :P4.5Pr es s ENT. t o Sel ec tsee page 5329