Instruction Manuals - Cole-Parmer

Instruction Manual pH 1100/ 21001.4 Electrode HolderThe electrode holder is included in the same box as the meter.To attach the electrode holder to the meter:1. The electrode holder base attached to thebottom of the meter comes in the shippingposition. See Figure 3.2. Use a Phillips screwdriver to remove thescrew holding the electrode holder inshipping position. See Figure 3.3. Slide the electrode base away from themeter until the second screw slot lines upwith the original screw hole. Use the screwremoved earlier to secure electrode holderbase into position. See Figure 3.4. The electrode holder arm is reversible. Ifdesired, remove screw holding electrodeholder base and slide base out of brackets.Slide base into brackets on opposite sideand replace screw.5. To install the electrode arm, turn meter backto the upright position. See Figure 4.6. Line up the hole on the base of theelectrode holder arm with the peg on theelectrode holder base. Slide the holesecurely onto the electrode holder base.See Figure 4.Figure 3: Bottom of Meter7. The electrode arm is now ready to swinginto desired position.Figure 4: Fix electrode holder arm to holder base9