GM862-GPS Software User Guide - SemiconductorStore.com

GM862-GPS Software User Guide1vv0300729 Rev. 4 - 24/01/07For example:command:AT#MONI=0Answer:OKcommand:AT#MONI?Answer:#MONI: I TIM BSIC:23 RxQual:7 LAC:AEAD Id:5265 ARFCN: 59 PWR: -80 dBm TA:0OKIn this case the mobile is registered on the network "I TIM", the signal strength is -80dBm (MMI mayindicate 4 antenna bars as reported on the table 5). The other information received is strictly technicaland should not be given to the user.For example2:command:AT#MONI=0Answer:OKcommand:AT#MONI?Answer:#MONI: Cc: 010 Nc: 03 BSIC:23 RxQual:7 LAC:0001 Id:0001 ARFCN: 60 PWR: -83 dBm TA:0OKIn this case the mobile is registered on the network whose Country code is 010 and Network operatorcode is 03, the signal strength is -83dBm (MMI may indicate 4 antenna bars as reported on the table5). The other information received is strictly technical and should not be given to the user.The values reported are random and have no meaning they are used only to explain command usage.NOTE: This command should be used only to gather information on network name and signalstrength, to check if mobile is registered or is looking for a suitable network to register to, usealways the +CREG command. This is due to the fact that if the network signal is too weak andmobile looses the registration, until a new network is found the #MONI command reports thelast measured valid values and not the real ones.The TA (timing advance parameter) is valid only during a call.TIP: To properly use this feature, check network registration with command +CREG as seen onpar. 2.5.3.1 and when mobile is registered query the mobile for network operator name andsignal strength with #MONI command.Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 18 of 111