GM862-GPS Software User Guide - SemiconductorStore.com

- page number - total number of pages of the message - CBM Content of MessageGM862-GPS Software User Guide1vv0300729 Rev. 4 - 24/01/07 - SMS-STATUS-REPORTs reporting option0 - status report receiving is not reported to the DTE1 - the status report is sent to the DTE with the following unsolicited result code:+CDS: where: - PDU length - message PDU(PDU Mode)(TEXT Mode)+CDS: ,,,,,,where: - first octet of the message PDU - message reference number - arrival time of the message to the SC - sending time of the message - message status as coded in the PDU2 - if a status report is stored, then the following unsolicited result code is sent:+CDSI: ,where: - memory storage where the new message is stored"SM" - location on the memory where SM is stored - buffered result codes handling method:0 - TA buffer of unsolicited result codes defined within this command is flushed to the TE when=1..3 is entered (OK response shall be given before flushing the codes)1 - TA buffer of unsolicited result codes defined within this command is cleared when =1..3is entered.NOTE: issuing AT+CNMI is the same as issuing the Read command.• wait for OKNOTE: issuing AT+CNMI= is the same as issuing the command AT+CNMI=0.TIP: In this command description the values that are always 0 are parameter reserved for futureuse, in the current software revision the only value supported is 0.Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 59 of 111