GM862-GPS Software User Guide - SemiconductorStore.com

More documents

Recommendations

Info

3.1.5 Phonebook entry DeleteAs first thing, the desired storage must be active (see par.3.1.1.1). Then:• send command AT+CPBW=where: is the index number of the desired PB record to be deleted.• wait for response:GM862-GPS Software User Guide1vv0300729 Rev. 4 - 24/01/07Response Reason ActionOKRecord has been successfully proceed aheaddeletedERROR some error occurred Enable extended result codes(see par. 2.5.2.1), and retry.+CME ERROR: 21invalid index, out of PB storage check index number and retry.limits+CME ERROR: 10 SIM not present Check SIM or require SIMinsertion and repeat from par.2.5.2.2+CMS ERROR: 310 SIM not present Check SIM or require SIMinsertion and repeat from par.2.5.2.2+CME ERROR: 11SIM is present and PIN isrequired to continue operationsinsert SIM PIN (see par.2.5.2.3)+CMS ERROR: 311SIM is present and PIN isrequired to continue operationsinsert SIM PIN (see par.2.5.2.3)+CME ERROR: 12SIM is present and PUK isrequired to continue operationsinsert SIM PUK (seepar.2.5.2.4)+CMS ERROR: 316SIM is present and PUK isrequired to continue operationsinsert SIM PUK (seepar.2.5.2.4)+CME ERROR: 13 SIM defect Check SIM insertion or requirea new SIM not defected andrepeat from par. 2.5.2.2+CMS ERROR: 313 SIM defect Check SIM insertion or requirea new SIM not defected andrepeat from par. 2.5.2.2+CME ERROR: 14 SIM is busy retry later+CMS ERROR: 314 SIM is busy retry later+CME ERROR: 15 SIM is wrong type Check SIM, it must be a GSMSIM.+CMS ERROR: 315 SIM is wrong type Check SIM, it must be a GSMSIM.Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 36 of 111
GM862-GPS Software User Guide1vv0300729 Rev. 4 - 24/01/07TIP: The delete operation simply overwrites the record number with an empty record.If the record to be deleted was already empty, no error messages will be shown, but it will beonly filled again with empty values.3.1.6 Phonebook entry DialYou may want to dial a number previously stored in the phonebook. As first thing, you must find thedesired phone number index position, to do it use the +CPBF command. Once the number isknown set up the device for the type of call you want to dial. Then:• send command ATD> where: is the index number of the desired PB record to be dialed.wait for response according to the call type you issued.For example:1- Let's assume you want to make a Voice call on the internal audio path MT to "Fabio" whose numberis stored on the SIM PB:- Select the PB as active storagecommand:AT+CPBS="SM"responseOK- Now find the index number where "Fabio" is recorded:command:AT+CPBF="Fabio"the response may look like:+CPBF= 7,"+39404192369",145,"Fabio"OK- the first field is the index position: 7 in this case.- Now set up Voice call:command:AT+FCLASS=8response:OKAT#CAP=2 OKAT+CLVL=8OKReproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 37 of 111
Page 1 and 2: GM862-GPS Software User GuideGM862-
Page 4 and 5: GM862-GPS Software User Guide1vv030
Page 8 and 9: Command Time-Out (Seconds)#SHDN 10#
Page 12 and 13: 2.5.2.3 Provide SIM PIN (only if re
Page 20 and 21: For example:1 - Let's assume that t
Page 30 and 31: +CME ERROR: 17PIN2 is required to c
Page 34 and 35: AT+CPBR=7the response may look like
Page 86 and 87:
GM862-GPS Software User Guide1vv030
Page 88 and 89:
Page 90 and 91:
esponse:+CCLK="02/11/07,13:24:47"OK
Page 92 and 93:
Page 94 and 95:
Page 96 and 97:
Page 98 and 99:
Page 100 and 101:
Page 102 and 103:
Page 104 and 105:
Page 106 and 107:
5.6.4 GPS PARAMETERS SAVEGM862-GPS
Page 108 and 109:
Page 110 and 111:
show all

GM862-GPS Software User Guide - SemiconductorStore.com

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?