GM862-GPS Software User Guide - SemiconductorStore.com

More documents

Recommendations

Info

esponse:+CCLK="02/11/07,13:24:47"OKGM862-GPS Software User Guide1vv0300729 Rev. 4 - 24/01/07- calculate & set up the next alarm in order to raise the GPIO6 pin to power up the controllingapplication too.command:AT+CALA="02/11/07,14:24:47+01",0,6,"TIME TO MEASURE & SMS…!"response:OK- shutdown the GM862-GPS and successively the controlling application.command:AT#SHDNresponse:OKReproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 90 of 111
GM862-GPS Software User Guide1vv0300729 Rev. 4 - 24/01/074 GPRS operations4.1 IntroductionThe General Packet Radio Services (GPRS) standard permits DATA transfers in a completelydifferent way with respect to previous point to point communications made with Circuit Switch Data(CSD) GSM modems.In CSD operations the modem establishes a connection with the other party (another modem) in sucha way that all the Network devices in between are transparent to the data exchanged, simulating a realpoint to point connection, just as if the other party is directly connected with the controlling applicationof the modem. The other party can be either an Internet Service Provider (ISP) or a private server, butin any case, the arrival point must have a modem to connect to (Landline, ISDN or GSM CSD). Theconnection establishment procedure defines a particular path where all the information exchangedbetween the two peers flows and this path is reserved for exclusive use of these 2 peers for all thetime the connection is active.This approach has the drawbacks of a long time to set-up the link between the two peers (up to aminute) and a time counting bill which proceeds even if no data is exchanged because the pathresources are reserved anyway; furthermore the speed of the data transfer is limited to 14400 bps.An example of this kind of operation is shown in the following picture, where the point to pointconnection is between the two peers as if all the devices inside the dashed line are not present:CSD interconnectivityReproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 91 of 111
Page 1 and 2:
GM862-GPS Software User GuideGM862-
Page 4 and 5:
GM862-GPS Software User Guide1vv030
Page 6 and 7:
Page 8 and 9:
Command Time-Out (Seconds)#SHDN 10#
Page 10 and 11:
Page 12 and 13:
2.5.2.3 Provide SIM PIN (only if re
Page 14 and 15:
Page 16 and 17:
Page 18 and 19:
Page 20 and 21:
For example:1 - Let's assume that t
Page 22 and 23:
Page 24 and 25:
Page 26 and 27:
Page 28 and 29:
Page 30 and 31:
+CME ERROR: 17PIN2 is required to c
Page 32 and 33:
Page 34 and 35:
AT+CPBR=7the response may look like
Page 36 and 37:
3.1.5 Phonebook entry DeleteAs firs
Page 38 and 39:
Page 40 and 41: GM862-GPS Software User Guide1vv030
Page 106 and 107: 5.6.4 GPS PARAMETERS SAVEGM862-GPS
show all

GM862-GPS Software User Guide - SemiconductorStore.com

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?