GM862-GPS Software User Guide - SemiconductorStore.com

More documents

Recommendations

Info

GM862-GPS Software User Guide1vv0300729 Rev. 4 - 24/01/073.5.3 Writing a New SMS to storageA new SMS can be written in the selected storage (in the current SW version only "SM" issupported) and then can be sent to the desired destination.To write the new SMS:• send command AT+CMGW=""where:: destination address• wait for prompt ">"• send SMS text (MAX 160 characters)• end command with CTRL-Z character (0x1A hexadecimal) or abort command with ESC character(0x1B hexadecimal)• wait for response:Response Reason Action+CMGW: Message has been successfully proceed aheadwritten in position numberOKERROR some error occurred Enable the extended errorcodes report (see par.2.5.2.1)and retry.+CMS ERROR: 330 SMSC address unknown Insert SMSC address (see par.3.5.1.3)+CMS ERROR: 322 Memory Full memory is full, hence deletesome records and retry.NOTE: if command is aborted with ESC character, then only the OK result code is returned.Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 68 of 111
GM862-GPS Software User Guide1vv0300729 Rev. 4 - 24/01/07For example:1- Let's assume you want to write a new SMS to the storage and the destination address is thenumber +39338123456789. We suppose you already have set up the device for text SMS mode asdescribed on the previous paragraphs:command:AT+CMGW="+39338123456789"response:>now you can insert the message text in IRA format (note that the IRA format and ASCII formatcoincide for the alphabet characters but not for the other).…. here will be inserted the SMS message text….conclude text with the character CTRL-Zresponse:+CMGW: 3OKIn this case, the new SMS was successfully written to the location index 3 of the selected writememory (always "SM" SIM Card memory).Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 69 of 111
Page 1 and 2:
GM862-GPS Software User GuideGM862-
Page 4 and 5:
GM862-GPS Software User Guide1vv030
Page 6 and 7:
Page 8 and 9:
Command Time-Out (Seconds)#SHDN 10#
Page 10 and 11:
Page 12 and 13:
2.5.2.3 Provide SIM PIN (only if re
Page 14 and 15:
Page 16 and 17:
Page 18 and 19: GM862-GPS Software User Guide1vv030
Page 20 and 21: For example:1 - Let's assume that t
Page 30 and 31: +CME ERROR: 17PIN2 is required to c
Page 34 and 35: AT+CPBR=7the response may look like
Page 36 and 37: 3.1.5 Phonebook entry DeleteAs firs
Page 90 and 91: esponse:+CCLK="02/11/07,13:24:47"OK
Page 106 and 107: 5.6.4 GPS PARAMETERS SAVEGM862-GPS
show all

GM862-GPS Software User Guide - SemiconductorStore.com

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?