GM862-GPS Software User Guide - SemiconductorStore.com

GM862-GPS Software User Guide1vv0300729 Rev. 4 - 24/01/07145 - number in international format (contains the "+") - text length - TP-User_data• If indicates that GSM03.38 default alphabet is used , each character of GSM alphabet willbe converted into current TE character set (see +CSCS)• If indicates that 8-bit or UCS2 data coding scheme is used, each 8-bit octet will beconverted into two IRA character long hexadecimal number (e.g. octet 0x2A will be converted astwo characters 0x32 0x41)NOTE: in both cases if status of the message is 'received unread', status in the storage changes to'received read'.NOTE: an error result code is sent on empty record .For example:1- Let's assume you want to read the SMS that is stored at the position index 4. We suppose youalready have set up the device for text SMS mode as described on the previous paragraphs:command:AT+CMGR=4response:+CMGR: "STO UNSENT","+393351234565"Telit Test Message for Text Mode SMS.OKIn this case the SMS was successfully read, the text contained was:" Telit Test Message for Text Mode SMS."The message was written to the storage by user (STO) but still not sent (UNSENT) to the destinationaddress that's the number +3933512345652- Let's assume you want now to read the SMS that is stored at the position index 5:command:AT+CMGR=5response:+CMGR: "REC UNREAD","+393381234567890", ,"29/06/01,12:30:04+01"Telit Test Message for Text Mode SMS RECEIVING.OKIn this case the SMS was successfully read, the text contained was:" Telit Test Message for Text Mode SMS RECEIVING."The message was received (REC) from the number +393381234567890 at 12:30:04 the day 29/06/01in the European time zone +1.After this read command the message at index 5 becomes REC READ.Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 75 of 111