GM862-GPS Software User Guide - SemiconductorStore.com

More documents

Recommendations

Info

For example:1 - Let's assume that the desired audio path is always the internal MTCommand:AT#CAP=2Answer:OKGM862-GPS Software User Guide1vv0300729 Rev. 4 - 24/01/072 - Let's assume that the desired audio path has to be determined by HARDWARE pin AXECommand:AT#CAP=0Answer:OKNow set the hardware pin AXE in the desired status.2.6.1.3 Set the desired volume on the active audio path speaker outputThis setting is not strictly necessary; it is also possible to keep the default volume setting.• Send command AT+CLVL=where: is a number between 0 and 10 representing the volume setting:0 – minimum volume10 - maximum volume• wait for OK responseNOTE: The volume setting refers to the ACTIVE path ear line and is stored each time. Whenchanging audio path the volume setting will be reset to the previously stored value for thataudio path.Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 20 of 111
GM862-GPS Software User Guide1vv0300729 Rev. 4 - 24/01/072.6.1.4 Check for microphone mute settingThe microphone of the active path can be muted with an AT command; to be sure that it is not muted,it is suggested to check it with this command:• Send command AT+CMUT?• wait for response in the format:+CMUT: OKwhere: is the muting setting for the microphone:0 - microphone active1 - microphone mutedNOTE: The mute setting is different from Volume setting: it refers to both the audio paths, themute setting will remain even when changing audio path.2.6.2 Phone number dialing2.6.2.1 Dial a given phone number• Send command ATD where: is the phone number to be dialed• wait for response:Response Reason ActionOK The call has been placed Wait for the other party to liftthe receiver..BUSY The line called is busy retry laterNO ANSWERThe receiver did not answer the retry laterNO CARRIERcallCall placing has not beensuccessfulcheck for mobile registrationand signal strength (par. 0)Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 21 of 111
Page 1 and 2: GM862-GPS Software User GuideGM862-
Page 4 and 5: GM862-GPS Software User Guide1vv030
Page 8 and 9: Command Time-Out (Seconds)#SHDN 10#
Page 12 and 13: 2.5.2.3 Provide SIM PIN (only if re
Page 30 and 31: +CME ERROR: 17PIN2 is required to c
Page 34 and 35: AT+CPBR=7the response may look like
Page 36 and 37: 3.1.5 Phonebook entry DeleteAs firs
Page 70 and 71:
GM862-GPS Software User Guide1vv030
Page 72 and 73:
Page 74 and 75:
Page 76 and 77:
Page 78 and 79:
Page 80 and 81:
Page 82 and 83:
Page 84 and 85:
Page 86 and 87:
Page 88 and 89:
Page 90 and 91:
esponse:+CCLK="02/11/07,13:24:47"OK
Page 92 and 93:
Page 94 and 95:
Page 96 and 97:
Page 98 and 99:
Page 100 and 101:
Page 102 and 103:
Page 104 and 105:
Page 106 and 107:
5.6.4 GPS PARAMETERS SAVEGM862-GPS
Page 108 and 109:
Page 110 and 111:
show all

GM862-GPS Software User Guide - SemiconductorStore.com

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?