eWON General Reference Guide - Esco Drives & Automation

More documents

Recommendations

Info

General Reference GuideIO Servers ConfigurationThe device address is composed like following:MPInode address: MPI node address of the PLCMPI, MPI node addressReach by MPI the PLC with the node address 2node address: PROFIBUS node address of the PLCPROFIBUS, Profibus node addrReach by Profibus the PLC with the node address 9ISOTCPIP address : IP address of the PLC (ex: 10.0.120.204)Called TSAP : Transport Service Access Point (ex: 03.02)ISOTCP, IP address, CalledTSAPReach by ISOTCP the PLC at IP 10.0.120.204 with the TSAP 03.02ISOTCP, IP address, CalledTSAP,Subnet ID, MPI node addressIP address : IP address of the PLC (ex: 10.0.120.204)Called TSAP : Transport Service Access Point (ex: 03.02)Subnet ID : ID of the MPI subnetMPI node address : address of the PLCTable 104: MPI/ISOTCP device address syntaxImportant:If the PLC address is defined at the Topic level, it can be omitted in the Tag definition. In that case the Tag name will only containthe "ValueName".If the PLC address is specified at the Topic level, it will replace any address defined Tag by Tag.note:For an S7-300, it’s generally always 03.02 .For an S7-400, you have to take into account the slot number of the CPU.For example if the CPU is on slot 4 rack 0 use TSAP 03.04, if the CPU is on slot 5 rack 1 use TSAP 03,25.RG-001-0-EN ver 1.5 eWON® - 20/03/2009 - ©ACT'L sa Page 129
General Reference GuideIO Servers Configuration5.13 S7-200 (PPI - ISOTCP)5.13.1 IntroductionThe S7200 IO Server is dedicated to communicate directly with SIEMENS PLC of family S7-200.The eWON will connect directly to the PLC’s PPI interface.Since firmware 5.5, eWONs with an MPI port are able to communicate on a PPI MultiMaster bus.Then, to communicate with a S7-200 device you could use either an eWON with a serial port or an eWON with an MPI port.UsageMonoMastereWON is the ONLY Master on the PPI network.MultiMastereWON is not the only Master on the PPI network.Other masters (HMI or PPI multimaster programming cables)may be present at the same time on the PPI bus.eWON with SERIAL port(EWxxx0x)YesNoeWON with MPI port(EWxxx6x)Yes(since firmware 5.5)Yes(since firmware 5.5)Table 105: PPI MonoMaster/MultiMaster usageThe eWON acts always as MASTER.The standard serial port of eWON must be configure in RS-485 (with dipswitch) to communicate in PPI.The ISOTCP (Ethernet) is available on all the eWON types.5.13.2 Setup5.13.2.1 Gateway configurationFigure 99: Gateway parametersParameterDestination PPI AddressDescriptionIdentifies the PLC PPI Destination address when ISOTCP is used5.13.2.2 COM configuration (serial port)RG-001-0-EN ver 1.5 eWON® - 20/03/2009 - ©ACT'L sa Page 130
Page 1 and 2:
eWON Family500, 2001, 4001, 2101, 4
Page 3:
Table of content5.4.3 Tag name conv
Page 6 and 7:
General Reference GuideIntroduction
Page 8 and 9:
General Reference GuideeWON Configu
Page 10 and 11:
Page 12 and 13:
Page 14 and 15:
Page 16 and 17:
Page 18 and 19:
Page 20 and 21:
Page 22 and 23:
Page 24 and 25:
Page 26 and 27:
Page 28 and 29:
Page 30 and 31:
Page 32 and 33:
Page 34 and 35:
Page 36 and 37:
Page 38 and 39:
Page 40 and 41:
Page 42 and 43:
Page 44 and 45:
Page 46 and 47:
Page 48 and 49:
Page 50 and 51:
Page 52 and 53:
Page 54 and 55:
Page 56 and 57:
Page 58 and 59:
Page 60 and 61:
Page 62 and 63:
Page 64 and 65:
Page 66 and 67:
Page 68 and 69:
Page 70 and 71:
Page 72 and 73:
Page 74 and 75:
Page 76 and 77:
Page 78 and 79:
Page 80 and 81: General Reference GuideeWON Configu
Page 86 and 87: General Reference GuideIO Servers C
Page 148 and 149: General Reference GuideMonitoring W
Page 166 and 167: General Reference GuideRetrieving d
Page 168 and 169: General Reference GuideExport Block
Page 180 and 181:
General Reference GuideExport Block
Page 182 and 183:
Page 184 and 185:
Page 186 and 187:
Page 188 and 189:
Page 190 and 191:
Page 192 and 193:
Page 194 and 195:
General Reference GuideUpgrading th
Page 196 and 197:
Page 198 and 199:
Page 200 and 201:
General Reference GuideAppendix10 A
Page 202 and 203:
General Reference GuideAppendix10.5
Page 204 and 205:
Page 206:
show all

eWON General Reference Guide - Esco Drives & Automation

Create successful ePaper yourself

Delete template?

Save as template?