12.07.2015 Views

eWON General Reference Guide - Esco Drives & Automation

eWON General Reference Guide - Esco Drives & Automation

eWON General Reference Guide - Esco Drives & Automation

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

<strong>General</strong> <strong>Reference</strong> <strong>Guide</strong>IO Servers Configuration5.14 HITACHI IO Server5.14.1 IntroductionThe Hitachi IOServer allows the <strong>eWON</strong> to poll tags belonging to a HITACHI EH series PLC using its serial link or Ethernet interface.<strong>eWON</strong> uses standard H protocol (for serial RS232), station number H protocol (for serial RS485), and Ethernet H-protocol (for Ethernet).No remote maintenance functionality is provided by this IO server.5.14.1.1 Setup5.14.1.1.1 COM configurationFigure 104: HITACHI IOServer: COM setupParameterBaud RateParityDescriptionSpeed of the Serial port.Available speeds are 1200, 2400, 4800, 9600, 19200 Bauds or disabledThe parity to apply (None / Even / Odd)Databits The number of bits in data (7 or 8)Stop bit(s) The number of Stop bits (1 or 2)HW modeReply TimeoutChoose the Hardware mode of communication:• Ful Duplex HW handshaking (by default)• Full Duplex NO handshaking• Half duplexMaximum time the <strong>eWON</strong> will wait for a valid message responseTable 112: HITACHI IOServer: COM parametersThe <strong>eWON</strong> implements Transmission Control Procedure 1 (One way activation Control Procedure).When half-duplex mode is used (RS485), the <strong>eWON</strong> acts as master. So, no other master may be on the bus (eg: control panel or host).RG-001-0-EN ver 1.5 <strong>eWON</strong>® - 20/03/2009 - ©ACT'L sa Page 135

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!