eWON General Reference Guide - Esco Drives & Automation

General Reference GuideeWON Configuration3.4.2.2.1 Email on alarm configurationThe required configuration if an email must be sent in case of alarm. If an email must be sent through PPP, the system configuration (Main andCOM) must also be set up.Alarm action PropertiesEmail uponShort MessageEmail ToEmail CCEmail subjectEmail attachmentDescriptionChecks the alarm states triggering an email (ALM, ACK, RTN, END).In some cases it is useful to have the whole message sent in the subject. For example if youneed to route email to SMS.Usually this checkbox is disabled.List of TO email address comma (, or ;) separated.List of CC email address comma (, or ;) separated.Will be the subject of the email (except if short message is selected).Body text of the email.This text can include Export Block Descriptor inline with text or as attachment.Attachments to include in the Email must follow the syntax:&[EXPORT_BLOC_DESCRIPTOR_1] &[EBD_2]…There can be as many attachments as required.EXPORT_BLOC_DESCRIPTOR syntax is described in chapter “Export Block Descriptor” onpage 167Example:&[$dtRTGA_AN01$ftG] &[$dtEV$ftT]Will export Real time data of GA_AN01 as a graph and the event log file as a text file.Table 49: Email on alarm configuration controls3.4.2.2.2 SMS on alarm configurationWarning: Sending an SMS is only possible from an eWON that embeds a modem (c.f. Table 187 on page 203)Alarm action PropertiesSMS uponSMS DestinationSMS SubjectDescriptionChecks the alarm states triggering an SMS (ALM, ACK, RTN, END).A list of SMS_RECIPIENT; SMS_RECIPIENT;…See below for the SMS_RECIPIENT syntax.Will appear at the beginning of the SMS message.Table 50: SMS on alarm configuration controlsRG-001-0-EN ver 1.5 eWON® - 20/03/2009 - ©ACT'L sa Page 76