Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
WORDCLOCKWORDCLOCKWORDCLOCKWORDCLOCKThunderbolt Host Connection (<strong>Apollo</strong>)Important: When the Thunderbolt Option Card is used for the host <strong>com</strong>puterconnection, both units must have the Thunderbolt Option Card installed.Cables Required:• One Thunderbolt cable for connecting to the host <strong>com</strong>puter• One Thunderbolt cable for connecting between the two interfaces• One FireWire 800 cable for connecting between the two interfaces• One ADAT optical cable for connecting between the two interfaces** At sample rates of 88.2 kHz and 96 kHz, two ADAT optical cables are requiredExpander UnitPOWERADAT S/MUXWORD CLOCKINL175317531MICROPHONE INPUTPUSH 4PUSH 3PUSH 2PUSH 1OUT (2) OUT (1) IN (2) IN (1)OUTINS/PDIFINMONITORLINE OUTPUTLINE INPUTPORT ( 1) PORT ( 2)FIREWIREOUTUNIVERSAL AUDIO, INC.1394 800 (2) 1394 800 (1)75 OHMTERMOUTR 286428642Monitor UnitPOWERADAT S/MUXWORD CLOCKINL175317531MICROPHONE INPUTPUSH 4PUSH 3PUSH 2PUSH 1OUT (2) OUT (1) IN (2) IN (1)OUTINS/PDIFINMONITORLINE OUTPUTLINE INPUTPORT ( 1) PORT ( 2)FIREWIREOUTUNIVERSAL AUDIO, INC.1394 800 (2) 1394 800 (1)75 OHMTERMOUTR 286428642ThunderboltComputerConnect speakersand headphonesto monitor unitKey points for this setup:• Both units require the Thunderbolt Option Card• The lower <strong>Apollo</strong> is designated as the Monitor (master) unit• The upper <strong>Apollo</strong> is designated the as the Expander (slave) unit• The Monitor unit is connected to the host <strong>com</strong>puter via Thunderbolt(either <strong>Apollo</strong> Thunderbolt port can be used for this connection)• The Expander unit is not connected to the host <strong>com</strong>puter• Thunderbolt must be connected between the Expander and Monitor units(either <strong>Apollo</strong> Thunderbolt port can be used for this connection)• One cable must be connected between the Expander and Monitor units(either <strong>Apollo</strong> FireWire 800 port can be used for this connection)• One ADAT optical cable must be connected from the ADAT OUT (1) of theExpander unit to the ADAT IN (1) of the Monitor unit** At sample rates of 88.2 kHz and 96 kHz, a second ADAT optical must also be connected fromthe ADAT OUT (2) of the Expander unit to the ADAT IN (2) of the Monitor unit• Monitor, headphone, and auxiliary outputs are connected to the Monitor unit only<strong>Apollo</strong> <strong>Software</strong> <strong>Manual</strong>84Chapter 6: Multi-Unit Cascading
Change language