No320S Owner's Manual - Mark Levinson

2Basic Operation3 5 4 67IR Receiverpolaritymonopowerselectsetup enter display intensity balance mutevolumePREAMPLIFIERNº 320Sstandby1 8 9 10 11 12 2The numbers in the Nº 320S front panel illustration shown above correspond to the numbered items in the Front Panel Overviewsection that begins below.Front Panel Overview2-1Unless otherwise specified, the numbered items in this sectionindicate the commands the front panel performs during normaloperating mode. Refer to Section 3: Setup Menu and Section 4:Controls & Modes for information about other commands the frontpanel performs.1. power buttonPowers the Nº 320S on and off when the supplied power cordis connected to the ~ac mains connector and an electricaloutlet. When the Nº 320S is powered off, pressing the powerbutton connects power to the ~ac mains connector andpowers on the Nº 320S. When powered on, the Nº 320Sautomatically enters standby after completing the initializationsequence. When the Nº 320S is powered on, pressing the powerbutton disconnects power from the ~ac mains connector andpowers off the Nº 320S.NoteBefore operating the Nº 320S, make sure the ~ac mainsconnector label indicates the correct operating voltage (page1-7) for the current location.(continued)