No320S Owner's Manual - Mark Levinson

Controls & ModesMark LevinsonSLEEP (continued)When the –OFF– setting is selected, the Nº 320S does notautomatically enter standby. When a time increment setting isselected, the Nº 320S automatically enters standby after thedesignated amount of time has passed. For example, if the 2h30m setting is selected, the Nº 320S automatically enters standbyafter 2 hours and 30 minutes have passed.To set the sleep timer:1. Follow the instructions on the previous page to take theNº 320S out of standby.SLEEP –OFF–2. Press and hold the front panel or remote control standbybutton until the SLEEP parameter opens on the front paneldisplay as shown to the left.3. Press and release the standby button to cycle through allavailable SLEEP parameter settings.4-24. When the desired setting is selected, press the front panel orremote control enter button to close the SLEEP parameter.• Otherwise, the SLEEP parameter automatically closes afew seconds after the last command is received. If thisoccurs, the selected setting is automatically applied.NoteThe SLEEP parameter is set to –OFF– whenever the Nº 320Sis placed into standby.Display IntensityControls the illumination of front panel display characters andthe front panel standby LED. Four illumination levels are available,including FULL (100%), HALF (50%), DIM (25%), and OFF (0%).The factory-default illumination level is FULL (100%).When the OFF (0%) illumination level is selected:• The front panel display automatically activates whenever achange in status is detected.• The front panel standby LED lights at the FULL (100%)illumination level.