No320S Owner's Manual - Mark Levinson

Setup MenuMark LevinsonTeach IR Menu (continued)To teach Nº 320S IR commands to a learning remote control:1. Prepare the learning remote control to receive IR commands.2. Follow the instructions on page 3-2 to open the setup menu.3. Rotate the front panel select knob or press the remote controlselect ± buttons until Teach IR is selected.4. Press the front panel or remote control enter button to openthe Teach IR menu.• The VOLUME UP IR command will appear on the frontpanel display.5. Rotate the front panel volume knob or press the remote controlvolume ± buttons to scroll through all available IR commands.3-10SENDING -->6. When the desired IR command is selected, press the enterbutton to teach this command to the learning remote control.• The SENDING --> message will appear on the front paneldisplay as shown to the left to indicate that the associatedinfrared signal is being sent to the learning remote control.7. Repeat steps 5 and 6 until all desired IR commands have beensent.NoteThe Nº 31, Nº 31.5, Nº 37, Nº 39, and Nº390S remotecontrols can be used to control Nº 320S master volume level.This command is available over IR (not Link connections).Before using one of these remote controls to adjust Nº320Smaster volume level, make sure the digital transport setupmenu volume control parameter is set to fixed.