No320S Owner's Manual - Mark Levinson

Nº 320S Setup MenuSetup Menu ParametersDefaultPossibleParameter Setting SettingsMute -20.0dB -10.0 to -80.0dBMaxVol 80.0dB 40.0 to 80.0dBTrig. 12v,L 12v,L; 5v,PSw N/A N/AMute Determines the amount of master volume level attenuation that–10.0 to –80.0dB occurs when mute is activated with the front panel or remotecontrol mute button. The mute level can be set in 0.1dB incrementsbetween –10.0 and –80.0dB. The factory-default mute level is–20.0dB.MaxVol Determines the maximum master volume level setting in 0.1dB40.0 to 80.0dB increments between 40.0 and 80.0dB. The factory-default maximummaster volume level is 80.0dB.3-11Trig.12v,L; 5v,PConfigures the trigger output signal. Selecting the 12v,L settingconfigures the trigger output connector to send a 12V, level(constant) signal to the connected component whenever theNº 320S is taken out of standby. This signal is not present whenthe Nº 320S is placed into standby. Selecting the 5v,P signalconfigures the trigger output connector to send a 5V pulse signal,similar to that of a momentary contact switch, to theconnected component whenever the standby button is pressed.This signal is only present when the standby button is pressed.Sw Indicates the current software version operating in the Nº 320S,Non-adjustable allowing for quick comparison between the current softwareversion and most current software version available. Softwareupgrades can be performed with the RS-232 port, allowing softwareto be upgraded without disassembling the Nº 320S or disconnectingit from other components.(continued)