Operation Manual for - Mrclab.com

Ultrasonic milk analyzerBy pressing the buttons “up”▲ and ”down”▼, the operator has the possibilityto pass from one page result to another.If the device has an embedded option “Conductivity” and "conductivitymeasurement" started, the result is shown on the display, showing the basicresults replacing lactose results in the following way:C=xx.xxIn this case the Lactose result is shown on a new page - Page 3 Results.xx.xx is the measured milk sample’s conductivity in [mS/cm]. If the results areoutside the limits for this type of sample (see table from the AppendixConductivity measurement), the cursor flashes after the letter С, remindingthat the sample is not correct. On the printout it is printed as !!!.If the conductiity value is outside measuring range (2-14 mS/cm), thefollowing message appears on the display:C=OutRg (Out of Range), and on the printout there isn’t any line withconductivity value.3.2.3.2. Write down the results in the form. The results remain on the displaytill a new measurement is started. If the analyzer is connected to a computeror a printer, it sends the data to the computer or prints them.Operation manual 18/98