Operation Manual for - Mrclab.com

Ultrasonic milk analyzerMilkanalyzer xxxLCD vers xxMA vers yyMA ser. N. xxxxWhile the abalyser is ready for work, the display shows “Gettingready”3. After the analyzer is ready for work a sound signal is heard and thedisplay shows: “Analyzer ready”. Now the analyzer is ready for makingmeasurement in the first measuring mode (most often Cow).4. make measurement of reference samples with known values of thecorrected parameter several times. If the difference between the valuesof the parameter from the reference methods and milkanalyser are inthe limits for the parameter it may be considered that the correction issuccessfully made.If the discrepancy between the measurements from the milk analyser andclassical methods is bigger than is necessary to make second correctionaccording above described way.If after the second correction the results are unsatisfactory we recommendmaking a calibration of the analyser. In dependence of the conditions andyour requirements you may make the calibration using a personal computertype IBM PC and the company's calibration program or autonomous - byrecalibration.When making corrections or calibrations be 100% sure in the accuracy of thereference methods result.6.4. Recalibrating the milk analyser6.4.1. Running the analyser in mode Recalibrate6.4.1.1. Press the button Enter and without releasing it switch on the powersupply of the device, wait for the starting identification messages and releasethe button after the following message appears on the display:Release buttonto start setupOperation manual 29/98