DX6i Manual - Spektrum

To Select a Model TypeRotate the roller to highlight the desired model type ACRO (airplane) or HELI helicopter then press the rollerto program that model type in model memory. Note that when changing model type all programming from theprevious model will be erased and the new model will be reset to factory default settings.Model NameThe Model Name function is used to input and assign the model’s name to a specific memory, allowing easyidentification of each model’s program. Each model’s name is displayed on the main screen when that model isselected. Up to eight characters that include numbers and letters are available.Reduce photo to 13.5%To Enter the MODEL NAME FunctionPress the ROLLER and hold while turning on the transmitter. When SETUP LIST appears on screenrelease the roller.MODEL TYPEListAlternatively the setup list can be accessed from the main screen by pressing the roller to access the ADJUST LIST,then scrolling through the ADJUST LIST by rolling the roller to highlight SETUP LIST, then pressing the roller.ACROHELIMODEL TYPE appears on the lower section of the screen.To return to the main screenPress and hold the roller for more than 3 seconds then release the roller and the system will returnto the main screen.To return to the SETUP LISTRotate the roller to highlight LIST in the upper right corner then pressing the roller will return the system to theSETUP LIST screen.Reduce photo to 13.5%SETUP LISTMODEL TYPEMainRotate the roller to highlight MODEL NAME then press the roller to access the MODEL NAME function.Reduce photo to 13.5%SETUP LISTMainMODEL TYPEMODEL NAME 2MONITOR82 SPEKTRUM DX6i • RADIO PROGRAMMING GUIDE SPEKTRUM DX6i • RADIO PROGRAMMING GUIDE83