Facts & Figures Book - KPI-JCI

Washin g/Classifyin gApplication: The number of paddle and flight assemblies,as well as the angle of operation, can be varied dependentupon the amount of scrubbing or pre-conditioningrequired. As the number of paddles or angle of operationis increased, the operational characteristics of the unitchange, including increased scrubbing action, increasedretention time, reduced capacity and increased powerrequirements.Capacities/Specifications: Blademill capacity is indirectlya function of retention time. Each application willindicate a required period of time for effective washing,which actually determines the capacity of the unit. As arule of thumb, a blademill can be expected to processin the range of a coarse material washer with respect toraking capacity in TPH and requires approximately 1 ⁄4 to1⁄3 of the water required in a coarse material washer. Ifsufficient information is not available with regards to claycontent and solubility, the lower end of the coarse materialwasher range should be used. Blademills are offeredin single or twin screw configurations of the same size ascoarse material washers.ModelCapacity(TPH)BLADEMILLSMotor(HP)SINGLE SPIRAL CONFIGURATIONS.6524-15S6536-19S6548-23S60-75150-175200-250152540TWIN SPIRAL CONFIGURATIONS.6536-19T6548-23T300-350400-5002540WaterRequired(GPM)75-150100-200125-250175-350200-400MaxFeedSize(in.)2½”2½”3”2½”3”Approx.DeadLoad(LBS)6,9009,80017,70017,20031,100NOTE: Two motors required on twin units. 24” diameter unit offered onlyin single spiral configuration.Approx.LiveLoad(LBS)7,50015,80030,70028,30057,600106