Facts & Figures Book - KPI-JCI

VERTICAL SHAFT IMPACT CRUSHER—Specifications and Production CharacteristicsMinimum Standard ApproximateRecommended Capacity Impeller Recommended Explosion WeightMaximum Closed Feed Tube Effective Crushing Table Speed Electric Table/Anvil Chamber EV-Models (ElectricFeed Size (1) Circuit Diameter Range (2) Range Horsepower Clearance Volume WK 2 Shown)Model Inch MM Mesh Inch TPH MTPH RPM H.P. Inch MM Cubic Inch Lbs-Ft Lbs Kgs1500 (H) 2 50 #16 8 1 ⁄2 75-125 67-112 720-2000 75-150 10.4 260 4,635 1,100 13,200 6,0001500 (A) 2 50 #4 8 1 ⁄2 75-150 67-135 720-2000 150 — — 4,635 1,100 13,700 6,0002500 (H) 3 75 #16 11 3 ⁄8 150-250 135-223 700-1400 250 8.8 220 10,120 2,400 18,000 8,1822500 (A) 2 50 #4 11 3 ⁄8 150-300 135-267 700-1400 300 — — 10,120 2,400 19,000 8,18282 3 75 #16 14.0 250-400 227-356 800-1200 400-500 8.7 218 10,940 3,200 24,000 11,0004500 (H) 3 75 4M 16.0 300-450 267-401 800-1200 400-500 10.25 (256) 17,360 3,830 29,600 13,3204500 (H) 5 1253 ⁄8” 16.0 300-450 267-401 800-1200 400-500 11.75 294 17,360 3,830 29,600 13,3204500 (A) 2 1 ⁄2 63 #4 16.0 300-500 267-445 800-1200 400-500 — — 17,360 3,500 29,100 13,3203 ⁄8” 18.0 300-500 267-445 800-1080 400-600 14.75 369 26,020 5,600 32,100 14,595120 6 150NOTE: (H) in the model number denotes hardparts configuration also referred to as “standard configuration.”(A) in the model number denotes autogenous configuration. The specification and production rates shown apply to semi- and fully-autogenous.(1) Max feed size restriction can vary with regards to material density, crushability, elongation, and impeller table speed or configuration.(2) Feed size and throughput tonnage based on material weighing 100 lbs. per cubic foot.75Crushin g