Facts & Figures Book - KPI-JCI

TRIPLE ROLL CRUSHERSRECOMMENDED HPSize Electric Diesel (Continuous)** 3018 125 1753024 150 200** 3030 250 375** 4022 200 2754030 300 4004240 400 525** 5424 300 400** 5536 450 600APPROXIMATE CAPACITIES IN TPH*FOR OPEN CIRCUIT—SINGLE FEED(Use 85 percent of these values in closed circuit single feed only)Roll SettingsCrushin gSize1⁄4”1⁄2”3⁄4” 1” 1 1 ⁄4” 1 1 ⁄2” 2” 2 1 ⁄2”** 3018 37 75 112 150 187 2253024 52 104 156 208 260 312** 3030 65 130 195 260 325 390** 4022 58 117 176 234 292 350 468 5844030 79 159 238 318 398 476 636 7964240 105 212 317 424 530 634 848 1061** 5424 65 131 198 262 328 392 524 655** 5536 97 195 293 391 489 586 782 977*Based on 75% of theoretical ribbon of material of 100# / ft. 3 BulkDensity–capacity may vary as much as ± 25%. The capacity at a givensetting is dependent on HP, slippage, type of shells and feed size. To findYd. 3 / Hr., multiply by .74. For larger settings, consult factory.MAXIMUM FEED SIZE VS. ROLL SETTING* (INCHES)30” Dia. 40” or 42” 54” or 55”Rolls Dia. Rolls Dia. RollsSmaller Larger Max. Larger Max. Larger MaxSetting Setting Feed Setting Feed Setting Feed1⁄41⁄2 19⁄15 1 1 ⁄45⁄8 1 1 ⁄23⁄83⁄4 1 1 ⁄213⁄16 1 7 ⁄815⁄16 2 1 ⁄41⁄2 1 2 1 1 ⁄8 1 7 ⁄815⁄16 2 1 ⁄43⁄4 1 1 ⁄2 3 1 11 ⁄16 3 3 ⁄4 1 13 ⁄16 4 1 ⁄21 1 7 ⁄8 3 1 ⁄2 2 1 ⁄4 5 2 7 ⁄16 61 1 ⁄4 2 3 1 ⁄2 2 1 ⁄2 5 2 7 ⁄16 61 1 ⁄2 2 3 1 ⁄2 2 3 ⁄4 5 3 62 3 5 3 62 1 ⁄2 3 5 3 6*With smooth shells No beads Bead one shell Bead two shells** Not current production models69