Jansen-Economy 50 E30 Jansen-Economy 50 E30 Jansen-Economy 50 E30
331 Profile - gilbert
331 Profile - gilbert
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Beschlageinbau (D-221-2D-010)<br />
Montage des ferrures (D-221-2D-010)<br />
Installation of fittings (D-221-2D-010)<br />
<strong>Jansen</strong>-<strong>Economy</strong> <strong>50</strong> <strong>E30</strong><br />
<strong>Jansen</strong>-<strong>Economy</strong> <strong>50</strong> <strong>E30</strong><br />
<strong>Jansen</strong>-<strong>Economy</strong> <strong>50</strong> <strong>E30</strong><br />
Umlenkschloss 555.394<br />
Standflügel<br />
Verrou de dérivation 555.394<br />
Vantail semi-fixe<br />
Off-set lock 555.394<br />
Secondary leaf<br />
555.387<br />
ø10<br />
555.387<br />
32<br />
25<br />
25<br />
25 (1 25 (1<br />
14<br />
22 14<br />
14<br />
G-Mass + 4<strong>50</strong><br />
22 14<br />
247<br />
25<br />
25<br />
G-Mass + 4<strong>50</strong><br />
124 123<br />
247<br />
11<br />
11<br />
32<br />
ø 23<br />
124 123<br />
11<br />
269<br />
555.394<br />
555.490<br />
32<br />
555.394<br />
32<br />
G-Mass + 4<strong>50</strong><br />
11<br />
269<br />
32<br />
1) Achtung: Bohrabstände überprüfen!<br />
Je nach Rosetten-Fabrikat unterschiedliche Masse.<br />
1) Attention: Vérifier les écarts de perçage!<br />
Dimensions différentes enfonction du type de rosace.<br />
1) Important: Check spacing of drill holes!<br />
Different dimensions, depending on the rosette manufacturer.<br />
Einbau mit 499.159<br />
Montage avec 499.159<br />
Installation with 499.159<br />
33-118<br />
09/2012