MDrive 23 Plus2 EtherNet/IP - Koco Motion GmbH

More documents

Recommendations

Info

Revision R061411 10 Accessories and spare parts 60 Page intentionally left blank MDrivePlus EtherNet/IP Integrated Motion System
V1.000, 10.2011 MDrivePlus EtherNet/IP 11 Service, maintenance and disposal 11 Service, maintenance and disposal Integrated Motion System DAMAGE TO SYSTEM COMPONENTS AND LOSS OF CON- TROL Interruptions of the negative connection of the controller supply voltage can cause excessively high voltages at the signal connections. • Do not interrupt the negative connection between the power supply unit and load with a fuse or switch. • Verify correct connection before switching on. • Do not connect the controller supply voltage or change its wiring while the is supply voltage present.. Failure to follow these instructions can result in injury or equipment damage. RISK OF INJURY WHEN REMOVING CIRCUIT BOARD PLUGS • When removing them note that the connectors must be unlocked. 11 – Supply voltage VDC: unlock by removing locking screws – I/O interface: unlock with locking tabs • Always hold the plug to remove it (not the cable). Failure to follow these instructions can result in injury or equipment damage. The product may only be repaired by a certified customer service center. No warranty or liability is accepted for repairs made by unauthorized persons. 61
Page 1 and 2:
MDrive 23 Plus 2 EtherNet/IP Produc
Page 3 and 4:
Important information This manual i
Page 5 and 6:
V1.000, 10.2011 MDrivePlus EtherNet
Page 7 and 8:
Page 9 and 10:
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
Page 17 and 18: V1.000, 10.2011 MDrivePlus EtherNet
Page 67: Revision R061411 MDrivePlus EtherNe
Page 81 and 82: WARRANTY TWENTY-FOUR (24) MONTH LIM
show all

MDrive 23 Plus2 EtherNet/IP - Koco Motion GmbH

Create successful ePaper yourself

Delete template?

Save as template?