MDrive 23 Plus2 EtherNet/IP - Koco Motion GmbH
MDrive 23 Plus2 EtherNet/IP - Koco Motion GmbH
MDrive 23 Plus2 EtherNet/IP - Koco Motion GmbH
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
V1.000, 10.2011<br />
<strong>MDrive</strong>Plus <strong>EtherNet</strong>/<strong>IP</strong> 11 Service, maintenance and disposal<br />
11 Service, maintenance and disposal<br />
Integrated <strong>Motion</strong> System<br />
DAMAGE TO SYSTEM COMPONENTS AND LOSS OF CON-<br />
TROL<br />
Interruptions of the negative connection of the controller supply<br />
voltage can cause excessively high voltages at the signal connections.<br />
• Do not interrupt the negative connection between the power<br />
supply unit and load with a fuse or switch.<br />
• Verify correct connection before switching on.<br />
• Do not connect the controller supply voltage or change its<br />
wiring while the is supply voltage present..<br />
Failure to follow these instructions can result in injury or<br />
equipment damage.<br />
RISK OF INJURY WHEN REMOVING CIRCUIT BOARD PLUGS<br />
• When removing them note that the connectors must be<br />
unlocked.<br />
11<br />
– Supply voltage VDC: unlock by removing locking screws<br />
– I/O interface: unlock with locking tabs<br />
• Always hold the plug to remove it (not the cable).<br />
Failure to follow these instructions can result in injury or<br />
equipment damage.<br />
The product may only be repaired by a certified customer service center.<br />
No warranty or liability is accepted for repairs made by unauthorized<br />
persons.<br />
61
Change language