TT CME Gateway System Administration Manual - Trading ...

A Configuration Parameters
A1=40
G1=30
G2=40
M1=10
M2=21
P1=10
P2=21
U1=10
CME Gateway System Administration Manual 127
Trading Technologies International, Inc.
Parameter Description
These values set the associated CTI/Origin values for all
orders that get sent through the order session.
The first digit of the value (e.g., for A1 listed on the left, this
is 4) is the CTI value and the second digit is the origin value
(origin of the order or fill). For example, if a parameter has
a value of 41, it has a CTI value of 4 and an Origin value of 1.
If you change CTI/Origin mappings, you must stop and
restart the Order Server before those particular mappings
become active.
The accounts are:
• A1 = 1st Agent
• G1 =1st giveup
• G2 = 2nd giveup
• M1 = 1st market maker
• M2 = 2nd market maker
• P1 = 1st proprietary
• P2 = 2nd proprietary
• U1 = Unallocated
The associated numeric values for CTI are:
• 1: Member Trader
• 2: Proprietary
• 3: On Behalf of Other Traders
• 4: Customers
The associated numeric values for Origin are:
• 0: Customer
• 1: Firm or House (Non-customer)
GiveupAccounts Sets whether orders that carry the specified account type
(i.e., G1) have multiple Give Up accounts. If X_TRADER®
submits an order with the specified account type, the CME
Gateway does not send a give-up firm. The CME Group
assumes that the order is given up to multiple firms. Mapping
is taken care of by CME Group’s back end.
For a description of configuring Give Up orders, refer to the
section called MultiFirm Give Up Orders on page 107.
Table 4. [order_session_#] section parameters