TT CME Gateway System Administration Manual - Trading ...

2 Installing and Upgrading
Additional Installation
Arguments
CME Gateway System Administration Manual 41
Trading Technologies International, Inc.
Argument Function
--skipdesktop Sets the installation to not add desktop icons.
--ttmdcfg=ttmd.cfg, ovr Sets the location of the ttmd.cfg file. You must set
this value equal to ttmd.cfg.
In addition, you must add the ovr argument to
overwrite an existing ttmd.cfg file.
Install Location Arguments
Warning: The following arguments only apply if this is the first TT product installed on the
server. Subsequent installations automatically write to an existing TT folder, even if you
supply the following arguments.
--installroot=[path] Sets the directory path for all install files and
folders and suppresses the prompt for installation
path during first time installations.
--installconfig=[path] Suppresses the Customize Destination Folders
dialog and sets the location for the hostinfo.cfg,
custommultipliers.cfg, ttchron.ini and
ttclean.ini configuration files.
Also, this argument sets the location of additional
TT component configuration files (i.e., ttmd.cfg,
DNModifications.cfg).
--installdata=[path] Sets the location for system data files.
--installuserdata=[path] Sets the location for user data files.
--installlog=[path] Sets the location for log files.
--installpathlist=[pathlist] Sets the location for all files listed above (i.e.,
configuration, log, user, and system data files).
The value of this parameter must equal a comma
separated list of installation paths that must
include the installroot and must appear in the
following order:
installroot,installconfig,installlog,installuserdata,in
stalldata
Any omitted values causes those files to be written
to the installroot location.
Table 6. Installation Arguments
Note: You can not add this argument to an
installation configuration file.
TT Gateways 7.16 and higher support an additional command line argument for
setting the gateway mode on install.