TT CME Gateway System Administration Manual - Trading ...

5 Configuring Order Management
CME Gateway System Administration Manual 99
Trading Technologies International, Inc.
1. Using a text editor, open :\tt\config\hostinfo.cfg
2. Configure the following parameters.
Parameter Description
[location] This section is required for all order routing
CME Gateways and applies to all order sessions
configured on the Gateway.
WARNING: If the [location] section is
missing, commented-out, or configured
incorrectly in the hostinfo.cfg file on an order
routing CME Gateway, the Gateway will not
start and will appear Red in Guardian.
Country Required parameter that sets the location of
the CME Gateway originating the session logon
and other administrative messages
(Heartbeat, Test Request, Resend Request,
Sequence Request and Logout).
This parameter is not case-sensitive. Valid
values are a 2-character ISO country code
(e.g., Country=US). ISO country codes are
provided by the CME Group at:
ftp.cmegroup.com/fix/coo
WARNING: If the Country parameter is
missing, commented-out, or does not specify a
2-character value or is configured incorrectly,
the gateway will not start and will appear Red
in Guardian.
Note: The CME Gateway does not validate the
actual ISO code values entered in this section;
it just checks whether it was entered as a 2character
value. The exchange will audit these
values for accuracy; however, invalid ISO
codes will not cause order actions to be
rejected.
StateProvince Optional parameter that sets the location of
the CME Gateway originating the session logon
and other administrative messages
(Heartbeat, Test Request, Resend Request,
Sequence Request and Logout).
This parameter is not case-sensitive. Valid
values are a 2-character ISO state or province
(e.g., StateProvince=IL). ISO state and
province codes are provided by the CME Group
at: ftp.cmegroup.com/fix/coo.
WARNING: If the StateProvince parameter
does not specify a 2-character value or is
configured incorrectly, the gateway will not
start and will appear Red in Guardian.
Note: The CME Gateway does not validate the
actual ISO code values entered in this section;
it just checks whether it was entered as a 2character
value. The exchange will audit these
values for accuracy; however, invalid ISO
codes will not cause order actions to be
rejected.
Table 15. Mandatory iLink Tag Configuration Parameters
3. Save the changes and close the file.