1. D-BACS - Daikin
1. D-BACS - Daikin
1. D-BACS - Daikin
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
intelligent Touch Controller<br />
5.6 DIII-NET Plus Adaptor Connection<br />
In order to increase the number of indoor units to be controlled, connect DIII-NET Plus adaptor using<br />
RS232-C cable attached to the adaptor.<br />
For details, refer to the installation manual of DIII-NET Plus adaptor.<br />
><br />
Don't clamp these cables together with high<br />
voltage cables. Failure to observe this<br />
instruction would cause control error.<br />
5.7 Connection for Unification Adaptor<br />
DAIKIN DIII-NET Plus Adapter<br />
CPU Alive<br />
In order to perform total start and stop/situation monitoring from central supervisory board, etc.,<br />
connect a Unification Adaptor sold separately.<br />
As shown in the sketch below, open the controller and connect the cable from the Unification Adaptor to<br />
CN2 connector located on the printed board on the lower case.<br />
If you route the cable in the cable guide groove on the lower case, you can make a smart connection without<br />
any slack of the cable.<br />
><br />
Don't clamp these cables<br />
together with high voltage cables. Failure to<br />
observe this instruction would cause control error.<br />
CN2<br />
108 5.6 DIII-NET Plus Adaptor Connection<br />
CN2<br />
W1 W2 W3 W4<br />
LINE PHONE RS-232C LAN<br />
B1<br />
B2<br />
BC