Web Gateway 7.1.5 Product Guide - McAfee

Add a new rule set
You can also create rule sets of your own to add them to the appliance configuration.
Complete this procedure to add a new rule set:
1 Go to Policy | Rule Sets.
Rules and rule sets
Rule set configuration 4
2 On the rule set tree, navigate to the position where you want to insert the new rule set.
3 Click Add above the rule set tree. A drop-down menu opens.
4 Select Rule Set. The Add New Rule Set window opens.
Figure 4-12 Add New Rule Set window
5 Configure the following general settings for the rule set:
• Name — Name of the rule
• Enable — When selected, the rule set is enabled
• [Optional] Comment — Plain-text comment on the rule set
6 In the Applies to section, configure the processing cycles. You can select only one cycle, or any
combination of these three:
• Requests — The rule set is processed when requests from the users of your network are received
on the appliance.
• Responses — The rule set is processed when responses from web servers are received.
• Embedded objects — The rule set is processed for embedded objects sent with requests and
responses.
7 In the Apply this rule set section, configure when the rule set is applied:
• Always — The rule set is always applied.
• If the following criteria is matched — The rule set is applied if the criteria configured below is
matched.
McAfee Web Gateway 7.1.5 Product Guide 109