Web Gateway 7.1.5 Product Guide - McAfee

3
Proxies and caching
Reverse HTTPS proxy configuration
Create rules for setting the URL.Host property
To create rules that set the URL.Host property to the appropriate value for the IP addresses the
appliance listens to, proceed as follows:
1 Go to Policy | Rule Sets.
2 On the rule sets tree, select the rule set you have created for the new rules, for example, Set
URL.Host property according to particular IP addresses.
3 Click Add Rule. The Add Rule window opens.
4 Under Name, enter a name for the new rule, for example, Set URL.Host property for IP address
10.141.101.51.
5 Under Rule Criteria, select If the following criteria is matched and click Add. The Add Criteria
window opens.
6 Configure the rule criteria as follows:
• From the Property list, select URL.Destination.IP.
• From the Operator list, select equals.
• In the Value field under Parameter, type the IP address you want to match to a host name, for
example, 10.141.101.51l.
7 Click OK. The window closes and the new criteria appears under Rule Criteria.
8 Under Action, select Continue and leave the default settings for this action.
9 Under Events, click Add and then Set Property Value. The Add Set Property window opens.
10 Set a property as follows:
• Under Set this property, select URL.Host.
• Under To concatenation of these strings, click Add. The Please enter a string window opens.
• In the Value field, type the host name you want the IP address to match.
11 Click OK. The window closes and the new event appears under Events.
12 Click Finish. The Add Rule window closes and the new rule is inserted in the rule set you configured
for it.
13 [Optional] Repeat Steps 3 to 12 for every other rule you want to add.
14 Click Save Changes.
64 McAfee Web Gateway 7.1.5 Product Guide