Hybrid Restorations with the CAMLOG Implant System (PDF

HYBRID RESTORATIONS WITH THE CAMLOG ® IMPLANT SYSTEM
BAR RESTORATIONS
INSERTING THE BAR CONSTRUCTION
The CAMLOG ® bar abutments are transferred from the working cast to the
CAMLOG ® implants and screwed in definitely with the prescribed torque.
The finished bar construction is transferred to the CAMLOG ® bar abutments
and fixed definitely with 15 Ncm with new unused prosthetic screws,
using a screwdriver (hex). The newly created full denture is then inserted
and checked for proper fit.
SLEEVE FOR TITANIUM BONDING BASE,
BURN- OUT (PASSIVE FIT)
Cast bar version with prefabricated bar sleeve made of burn-out plastic
(POM) for full casting technique and titanium bonding base as a retaining
element for the implant. The Passive Fit System makes it possible to fabricate
cast bars absolutely tension-free. For bar fabrication, the bar sleeve is
placed over the titanium bonding base. After completing the bar, it is
bonded to the implants with the titanium bonding bases. The plastic sleeve
of the bar base can be shortened occlusally to the height of the prosthetic
screw. The overall height of the plastic sleeve is 14 mm.
EXAMPLE:
WORKING CAST WITH CAMLOG ® LAB ANALOGS
(TITANIUM ALLOY).
WAX-UP
The bar wax-up is created based on the planning on the burn-out bar base
directly. The wax thickness over the plastic coping should be at least 0.3 mm.
Do not cover the delicate edge of the base with wax. Prefabricated bar
components made of wax / plastic can also be used to fabricate a premilled
bar construction.
Embedding, casting and devestment happen as described on page 28–29
"BASE FOR BAR ABUTMENT, BURN-OUT".
30
Sleeve for titanium bonding base,
burn-out, bondable (passive fit)