Hybrid Restorations with the CAMLOG Implant System (PDF

HYBRID RESTORATIONS WITH THE CAMLOG ® IMPLANT SYSTEM
BAR RESTORATIONS
PREPARING AND FABRICATING THE RELINING MODEL
The soldering aid/bar lab analog that fits is selected based on the diameter
used. It is inserted into the bar base and holds with the friction of the holding
pin for bars. Ensure the proper fit of the soldering aid/bar lab analog in
the bar base. Also use sticky wax or similar to hold the soldering aid/bar lab
analog if necessary.
The relining model is then fabricated in the usual way.
RELINING
After fabricating the relining model, the bar is placed on the model and attached
with prosthetic screws for bar abutments.
The areas underneath are blocked out. The relining is then finished in the
usual way based on the procedure for relining a bar-supported prosthesis.
REPLACING THE BAR AND PROSTHESIS
The bar is fixed in the patient's mouth using unused prosthetic screws for bar
abutments. The bar is inserted and the prosthetic screws are tightened to
the specified torque of 15 Ncm. The prosthesis is then inserted and checked
for proper seating and occlusion.
38
Holding pin for bar, bar base,
soldering aid/bar lab analog