Hybrid Restorations with the CAMLOG Implant System (PDF

BONDING THE MATRICES IN THE METAL REINFORCEMENT
The bonding surfaces are conditioned. The manufacturer’s bonding directions
must be observed. The matrices can be bonded to the framework. The
lamella retention insert must be deactivated and insulated before bonding.
When deactivated, the lamella retention insert must not extend above the
margin of the matrix, otherwise the matrix will lift up from the CAMLOG ®
ball abutment. The matrices are clipped to the CAMLOG ® ball abutments
and aligned parallel, accordingly the position set during fabrication of the
duplicate cast.
Bonding is performed with a metal attachment bond material accordingly
the instruction by the manufacturer.
SET-UP AND TRY-IN
The teeth are set up with the silicone index on the metal reinforcement. The
denture is completely waxed and prepared for try-in. The try-in is conducted
with deactivated matrices. The vertical height, occlusion, articulation, tension-free
seating and esthetics are checked during this process.
FINISHING
After the try-in, finishing is continued with heat- or cold-cured polymerization
in the usual manner. The framework can be coated with pink opaquer
beforehand. The matrix housing must be sealed to prevent entry of acrylic
(wax, silicone, etc.). The ball abutment-retained full denture must be easy
to clean and must function correctly to ensure long-term success.
Bonding the matrices in the metal
reinforcement
HYBRID RESTORATIONS WITH THE CAMLOG ® IMPLANT SYSTEM
Finished ball abutment-supported
full denture
45