RF MODULE

20 Select the Solve using solver sequence check box, then click OK to close the Solver
Manager.
21 Solve by clicking the Solve button on the Main toolbar.
POSTPROCESSING AND VISUALIZATION
Follow these instructions to reproduce the plot in Figure 3-11 on page 97 visualizing
the structural deformation.
1 Open the Plot Parameters dialog box and clear the Slice check box in the Plot type
area on the General page. Instead, select the Boundary and Deformed shape plots.
2 On the Boundary page, select Shell (smsh)>Total displacement from the Predefined
quantities list. From the Unit list, select µm.
3 On the Deform page, clear the Subdomain check box in the Domain types to deform
area.
4 Click Apply to generate the plot, then click the Headlight button on the Camera
toolbar to finish it.
To visualize the total mesh displacement, add a slice plot according to the following
steps.
1 In the Plot Parameters dialog box, click the Slice tab and select the Slice plot check
box.
2 In the Slice data area, enter the Expression sqrt(dx_ale^2+dy_ale^2+dz_ale^2).
Change the Unit to µm.
3 In the Slice positioning area, change the number of X levels to 1.
4 In the Slice color area, change the Color table to Thermal.
THERMAL DRIFT IN A MICROWAVE FILTER | 105