Old School Chopper Frame Fabrication - Knucklebuster

More documents

Recommendations

Info

Figure 14 The cut we want to make for the time being should run parallel to the frame centerline removing about two inches of tubing. This should be done to both halves of the wishbones. This is not the final notching step. At this stage we just want to be able to insure that we can set the wishbones at the correct spacing. In effect what we will be creating is a straight mitered cut in the tube ends as if we were going to weld them together without a backbone tube between them.
Figure 15 Figure 15 shows the end results of this trimming. Note how we used the spacer tubes fabricated earlier to temporarily set the 8-3/8” inside width and that the wishbone tubes come together in an apex on the imaginary backbone centerline. Figure 16 is the same layout but shown from a different angle.
Page 1 and 2: Old School Chopper Frame Fabricatio
Page 3 and 4: 1. Steering head. Also called the s
Page 5 and 6: Figure Error! Bookmark not defined.
Page 11 and 12: Figure 11 This cross member sets th
Page 13: Figure Error! Bookmark not defined.
Page 17 and 18: Figure 17 There is a corresponding
Page 19 and 20: Figure 19 I call this area of the f
Page 21 and 22: Figure 23 The slope angle of the 'r
Page 23 and 24: In Figure 3 we can see the two tube
Page 25 and 26: Figure 1 shows the basic components
Page 27 and 28: an eighth of an inch clearance betw
Page 29 and 30: Figure 6 In Figure 6 we've deepened
Page 31 and 32: Figure 2 if you look closely you ca
Page 33 and 34: angle finder. It explains is easy t
Page 35 and 36: Figure 6 In this shot I've propped-
Page 37 and 38: In case you're interested I messed
Page 39 and 40: Figure 3 Figure 3 depicts a plate t
Page 41 and 42: Figure 7 Figure 7 is another 'boxed
Page 43 and 44: Regardless of the style or type of
Page 45 and 46: Figure 13 At this point all you nee
Page 47 and 48: Figure 1 You'll no doubt realize th
Page 49 and 50: Figure 4 Actually the plate will be
Page 51 and 52: If you're building a frame without
Page 53 and 54: Figure 5 Now that the plates are in
Page 55 and 56: Figure 2 Clean the notch up slightl
Page 57 and 58: Figure 5 The frame in Figure 5 is o
Page 59 and 60: Figure 7 The tube in Figure 7 above
Page 62 and 63: We'll now begin doing the detail wo
Page 64 and 65:
The charge has been removed from th
Page 66 and 67:
Some people have reported problems
Page 68 and 69:
Steering Necks For some unexplained
Page 70:
Figure Error! Bookmark not defined.
show all

Old School Chopper Frame Fabrication - Knucklebuster

Create successful ePaper yourself

Delete template?

Save as template?